Bilt Hamber Touch-Less 5L

(1 customer review)


In stock

Fast delivery from £3.95 | Free over £30 (UK Mainland)
Next Day Available | 30 Day Return Policy
Further Delivery Information


TOUCH-LESS is a new eco-friendly pressure-washer, pre-clean, snow foam that can be applied with a  trigger spray, pump sprayer or snow foam lance.   Applied at typically a 4% PIR, this bio-degradable sugar-based product provides truly exceptional levels of cleaning of automotive paintwork.

Unlike other petrochemical-based cleaners, TOUCH-LESS is free-and-easy rinsing, easing the effort of subsequent bucket washes and massively helping post-treatments bond too.

TOUCH-LESS also contains corrosion inhibitors. Packed in 5 litres with a pH ~12, it contains no phosphates, solvents, NTA, or caustic soda.

TOUCH-LESS is designed to allow for superior and simple application of our new paint protection product TOUCH-ON.

How To Use Bilt Hamber TOUCH-LESS

TOUCH-LESS may be applied with trigger spray, pump spray, pressure washer, or snow foam lance. The minimum recommended dilution rate should be 2% PIR (Panel Impact Ratio) and up to 5% for very dirty vehicles. Where the application is through trigger spray or pump sprayer, the dilution calculation is easy to achieve, however, for application with pressure equipment it is essential to determine the amount of water being delivered to the equipment reservoir.

  1. Fill the detergent bottle or reservoir (on machine or lance) up to capacity with plain water. Turn detergent feed to full. Take a large bucket or container and discharge the lance into this, watching the detergent bottle until empty. Once empty, stop.
  2. The following calculations will achieve 4% dilution; Measure the total amount collected and multiply this number by 0.04 (Total can be measured in either volume with a measuring jug or by weight) this is the amount of TOUCH-LESS to use.
  3. Add the calculated amount from STEP TWO to the pressure-washer reservoir and top up to full with cold water and shake in for a few moments.
  4. Apply touchless to the entire vehicle or panel by panel. Allow it to soak for 1-5 minutes (but never allow to dry). Power-wash off.

It is not necessary to use all diluted touch-less in one wash. One litre of the diluted product should last 4-5 washes. Apply to cool panels in shaded conditions. Do not allow this product to dry in use. Keep the bottleneck and lid clean.

Bilt Hamber Touch-Less

1 review for Bilt Hamber Touch-Less 5L

  1. Graeme

    Touch – Less is an excellent pre wash foam, slightly less alkaline than Auto Foam but I found it cleans slightly better.
    Easier to rinse away with either power washer or even a garden hose and doesn’t leave foam on the drive for days.

    Can also be used in a pump sprayer or trigger sprayer if your fingers are up to the job.
    Full review of it can be found on my YouTube channel GM Details

Add a review

Your email address will not be published. Required fields are marked *